Skip survey header

Network+ Practice Quiz: N10-007 Quiz 16

Enjoy the following 10 question quiz from TestOut.

1. Which of the following are requirements of the 1000BaseT Ethernet standards? (Choose three)
2. You are planning a network for an educational campus. Due to the size of the buildings and the distance between them, you have elected to use 10BaseFL hubs, cabling, and network interface cards.

What is the maximum length for the network cable between a workstation and a hub?
3. Which Gigabit Ethernet standard uses multimode fiber optic cabling and supports network segments up to a maximum of 550 meters long?
4. You have been tasked with designing a high-speed Ethernet network. Your client's building already has 150-ohm shielded twisted pair (STP) wiring installed. Due to budget constraints, they have asked you to reuse the existing wiring instead of installing new fiber optic cabling.

Which Ethernet standard could you implement in this situation?
5. Which Gigabit Ethernet standard can support long network segments up to a maximum of 5 km when used with single-mode fiber optic cable?
6. You would like to implement 10 Gbps Ethernet over a distance of 1 kilometer or greater. Which of the following would be the minimum requirement for the implementation? (Choose two)
7. You need to transfer data from one laptop to another, and you would like to use an Ethernet cable. You do not have a hub or a switch.

Which type of cable should you use?
8. You want to connect the LAN port on a router to the uplink port on a switch. The switch does not support auto-MDI.

Which type of cable should you use?
9. You need to connect two switches using their uplink ports. The switches do not support auto-MDI.

Which type of cable should you use?
10. You need to connect a workstation to a switch using a regular port on the switch (not an uplink port). The switch does not support auto-MDI.

Which type of cable should you use?
This free quiz was provided by:



 
0%